Center Console End Panel Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Floor Console End Cap Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front floor console compartment bezel. Refer to Front Floor Console Compartment Bezel Replacement (Cadillac) or Front Floor Console Compartment Bezel Replacement (Except Cadillac) . Remove the front floor console rear cupholder. Refer to Cup Holder Replacement - Front Floor Console - Rear (Cadillac) or Cup Holder Replacement - Front Floor Console - Rear (Except Cadillac) .
1	Front Floor Console End Cap Screws (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Floor Console End Cap Assembly Tip: Disconnect the electrical connections.

Callout

Component Name

Preliminary Procedures

Remove the front floor console compartment bezel. Refer to Front Floor Console Compartment Bezel Replacement (Cadillac) or Front Floor Console Compartment Bezel Replacement (Except Cadillac) .
Remove the front floor console rear cupholder. Refer to Cup Holder Replacement - Front Floor Console - Rear (Cadillac) or Cup Holder Replacement - Front Floor Console - Rear (Except Cadillac) .

Front Floor Console End Cap Screws (Qty: 4)

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Front Floor Console End Cap Assembly
Tip: Disconnect the electrical connections.