LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Number 2 Hinge Finish Cover Replacement

Rear Seat Number 2 Hinge Finish Cover Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Hinge Finish Cover & Screws
GM1683822Courtesy of GENERAL MOTORS CORP.
Rear Seat Number 2 Hinge Finish Cover Replacement

Callout Component Name
Preliminary Procedure: 
Remove the Rear Seat No. 2 Back Cushion Cover. Refer to Seat Back Cover and Pad Replacement - Rear No. 2 .
1 Rear Seat Hinge Finish Cover Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)
2 Rear Seat Hinge Finish Cover
Tip:  Slide the belt out through the slit in the back of the bezel.
scientia non olet · About LEMON Manuals