Seat Back Cover and Pad Replacement - Rear No. 2

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Back Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear seat. Refer to Rear Number 2 Seat Replacement (Suburban/Yukon XL) or Rear Number 2 Seat Replacement (Tahoe/Yukon/Escalade) .
1	Rear Seat Hinge Finish Cover Refer to Rear Seat Number 2 Back Cushion Hinge Finish Cover Replacement (AW2) .
2	Rear Seat Head Restraint Assembly Refer to Head Restraint Replacement - Rear No. 2 .
3	Rear Seat Head Restraint Guide (Qty: 2) Refer to Head Restraint Guide Assembly Replacement - Rear No. 2 .
4	Rear Seat Shoulder Belt Bezel Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
5	Rear Seat Shoulder Belt Bezel Refer to Rear Seat Shoulder Belt Opening Bezel Replacement (Avalanche/Escalade EXT) or Rear Seat Shoulder Belt Opening Bezel Replacement (Tahoe/Yukon/Escalade Rear Seat No. 2) .
6	Rear Seat Back #2 Cushion Cover Tip: Disconnect the seat back cushion cover j-channel from the seat cushion frame.
7	Rear Seat #2 Cushion Pad Tip: Pull the seat back cushion cover away from the seat cushion pad to disengage the retaining channel.