LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Tires And Wheels) >> Repair Instructions >> Spare Tire Carrier Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Spare Tire Carrier Assembly
    GM1455917Courtesy of GENERAL MOTORS CORP.
  1. Install the spare tire carrier to the vehicle. Perform the following steps:
    1. Position the spare tire carrier to the rear bumper.
    2. Loose install the carrier bolts. Refer to the Service Alignment Procedure Service Alignment Procedure above for alignment.
    3. Connect the license plate lamp harness electrical connector.
    2. Fig 2: Removing Or Installing Spare Tire
    GM1455916Courtesy of GENERAL MOTORS CORP.
  2. Install the spare tire to the spare tire carrier.
  3. Install the spare tire mounting nuts.

    Tighten:  Tighten the nuts to 70 N.m (52 lb ft).

    4. Fig 3: Spare Tire Components
    GM1455913Courtesy of GENERAL MOTORS CORP.
  4. Install the spare tire cover (2).
  5. Install the spare tire stowage cover nut (1) until snug.
  6. Close and ensure that the spare tire carrier is latched.
scientia non olet · About LEMON Manuals