Service Alignment Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Latch Casting Square Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

The carrier should be loose installed to the vehicle.
Align the latch casting square, and tighten the bolts to specifications using the sequence shown.
Tighten: Tighten the bolts to 110 N.m (81 lb ft).

Fig 2: Inserting A Shim

Courtesy of GENERAL MOTORS CORP.

Swing the carrier into the latch pocket so the striker pin touches the latch mechanism.
Insert a shim (1) between the striker bottom and the latch pocket.
Early carriers with a red striker sleeve will require a 5 mm shim, all other carriers with a yellow sleeve will require a 3 mm shim.
Secure the hinge bolts using the specification shown above.
Remove the shim (1), the carrier is now aligned and ready for use.