LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 493 (HVAC System - Automatic) >> Repair Instructions >> Inside Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  2. Remove the left center pillar assist handle. Refer to Roof Rail Rear Assist Handle Replacement .
  3. Remove the center pillar garnish molding. Refer to Center Pillar Upper Garnish Molding Replacement .
  4. Remove the left sunshade. Refer to Sunshade Replacement .
  5. Gently pull down the headliner.
    6. Fig 1: View of Air Temperature Sensor Electrical Connector
    GM675996Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect the electrical connector from the inside air temperature sensor.
  7. Partially remove the inside air temperature sensor from the headliner.
  8. Remove the sensor grille from the inside air temperature sensor.
    9. Fig 2: Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS COMPANY
  9. Remove the inside air temperature sensor from the headliner.
scientia non olet · About LEMON Manuals