Windshield Pillar Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Windshield Side Garnish Molding Assembly

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Disable the roof rail SIR system. Refer to SIR Disabling and Enabling . Remove the front assist handle, passenger side only. Refer to Front Assist Handle Replacement .
1	Windshield Side Garnish Molding Cover
2	Windshield Side Garnish Molding Screw CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
3	Windshield Side Garnish Molding Assembly Procedure Tabs must be installed prior to retainers. Tabs to be fully seated in I/P trim panel retainer and valance panel. Disconnect electrical connectors.
4	Windshield Side Garnish Molding Retainer (Qty: 2)