Front Seat Heater Control Module Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Heater Control Module

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the driver or passenger seat back cushion cover and pad. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .
1	Front Seat Heater Control Module Rivet (Qty: 2) WARNING: Approved safety glasses and gloves should be worn when performing this procedure to reduce the chance of personal injury. Procedure Drill out the old rivets. Use new rivets for replacements.
2	Front Seat Heater Control Module Procedure Disengage the electrical connector. Disconnect the module from the bracket. Refer to Control Module References for replacement and setup information.

Callout

Component Name

Preliminary Procedure
Remove the driver or passenger seat back cushion cover and pad. Refer to Front Seat Replacement - Bucket (without HP2) , Front Seat Replacement - Bucket (with HP2) .

Front Seat Heater Control Module Rivet (Qty: 2)

WARNING:

Approved safety glasses and gloves should be worn when performing this procedure to reduce the chance of personal injury.

Procedure

Drill out the old rivets.
Use new rivets for replacements.

Front Seat Heater Control Module

Procedure

Disengage the electrical connector.
Disconnect the module from the bracket.
Refer to Control Module References for replacement and setup information.