LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Adjustable Pedal System) >> Repair Instructions >> Brake and Accelerator Pedal Adjuster Position Sensor Replacement (With Memory Seats) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position.
  2. Remove the driver knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) , Knee Bolster Replacement (Cadillac) .
    3. Fig 1: Locating Pedal Position Sensor Electrical Connector
    GM2178150Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the adjustable pedal position sensor jumper harness electrical connector (1).
    4. Fig 2: Identifying Pedal Adjuster Position Sensors
    GM2178151Courtesy of GENERAL MOTORS COMPANY
  4. Remove the adjustable pedal position sensor bolts (1).
    5. Fig 3: Identifying brake & accelerator Pedal Adjuster Position Sensor
    GM2178152Courtesy of GENERAL MOTORS COMPANY
  5. Remove the brake and accelerator pedal adjuster position sensor (1).
scientia non olet · About LEMON Manuals