Knee Bolster Replacement (Except Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Knee Bolster Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the left instrument panel outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement (Except Cadillac) , Instrument Panel Outer Trim Cover Replacement (Cadillac) . Remove the park brake release handle. Refer to Parking Brake Release Handle Assembly Replacement .
1	Knee Bolster Assembly Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Knee Bolster Assembly Procedure Disconnect the electrical connections, if applicable. If replacing the knee bolster assembly, transfer all necessary components.
3	Retainer Clip (Qty: 4)