LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Bosch Connectors (ECM) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Bosch Connectors
GM1709276Courtesy of GENERAL MOTORS COMPANY
  1. Locate the assist lever on the top of the connector. Move the assist lever to the forward position.
    Fig 2: Identifying Assist Lever In Forward Position
    GM1709277Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the connector from the component.
    3. Fig 3: View Of Releasing Locking Tabs
    GM1709273Courtesy of GENERAL MOTORS COMPANY
  3. Locate the dress cover locking tabs at the corners of the connector. Use a small flat-blade tool to release the locking tabs and remove the dress cover.
    4. Fig 4: View Of Terminal Positive Assurance (TPA) Connector
    GM1709274Courtesy of GENERAL MOTORS COMPANY
  4. The terminal positive assurance (TPA) is located in the front of the connector.
    5. Fig 5: View Of Removing TPA From Connector
    GM1709278Courtesy of GENERAL MOTORS COMPANY
  5. Use a small flat-blade tool to remove TPA from the connector.
    6. Fig 6: View Of Special Tools And Terminals
    GM1709275Courtesy of GENERAL MOTORS COMPANY
  6. Use the J-38125-213 or the J-38125-556 tool to release the terminals by inserting the tool into the terminal release cavity.
  7. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
  8. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) , Repairing Connector Terminals (Terminal Repair)  procedure.
  9. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
    10. NOTE:

    Ensure that the dress cover and connector body are both in the released position before reassembling. Failure to do so may cause damage to the connector and component.

  10. Reconnect the connector bodies.
scientia non olet · About LEMON Manuals