LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Power Door Lock System And Release Systems) >> Repair Instructions >> Rear Side Door Inside Handle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Door Trim Panel
    GM2387373Courtesy of GENERAL MOTORS COMPANY
  1. Pull the door trim panel away from the door and support the bottom of the trim panel on the door panel hooks. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
    2. Fig 2: View Of Rear Side Inside Door Handle Assembly & Bolts
    GM1694060Courtesy of GENERAL MOTORS COMPANY
  2. Remove the rear side door inside handle fasteners (1).
  3. Remove the rear side door inside handle fasteners assembly (2).
    1. Disconnect the electrical connector.
    2. Depress both tabs to remove the rear side door cable and pull the cable rearward out of the handle assembly.
scientia non olet · About LEMON Manuals