Rear Side Door Trim Panel Replacement (Extended Wheelbase)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Trim Panel Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the rear door window control switch. Refer to Rear Side Door Window Switch Replacement . If the water deflector remains with the door trim panel, refer to Rear Side Door Water Deflector Replacement .
1	Rear Side Door Locking Rod Knob Assembly Procedure Lower the window. Ensure locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push knob down, until detent tab touches locking rod opening cover. Push detent tab in to lock knob to locking rod.
2	Rear Side Door Trim Panel Cover
3	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
4	Rear Side Door Inside Handle Bezel Cover
5	Rear Side Door Trim Panel Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (18 lb in)
6	Rear Side Door Trim Panel Assembly Procedure Disconnect the electrical connectors. There are 2 hooks located on the lower portion of the door trim panel that are being used for service and manufacturing installation. If these hooks are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.
7	Rear Side Door Cable Retainer Procedure Depress both tabs to remove cable and pull cable rearward out of handle assembly. When reinstalling cable make sure that it is fully seated past the guide tab.
8	Rear Side Door Trim Panel Retainer (Qty: 10)