LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Power Door Lock System And Release Systems) >> Repair Instructions >> Rear Side Door Inside Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Side Inside Door Handle Assembly & Bolts
    GM1694060Courtesy of GENERAL MOTORS COMPANY
  1. Connect the rear side door cable. Ensure the cable is fully seated past the guide tab.
  2. Slide the rear side door inside handle assembly into place (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the rear side door inside handle fasteners and tighten to 2 N.m (18 lb in).
    4. Fig 2: Door Trim Panel
    GM2387373Courtesy of GENERAL MOTORS COMPANY
  4. Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
scientia non olet · About LEMON Manuals