LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Power Door Lock System And Release Systems) >> Repair Instructions >> Liftgate Close Actuator Bracket Replacement (Except Avalanche and EXT Escalade)

Liftgate Close Actuator Bracket Replacement (Except Avalanche and EXT Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Liftgate Close Actuator Module Bracket & Bolts
GM1725899Courtesy of GENERAL MOTORS COMPANY
Liftgate Close Actuator Bracket Replacement (Except Avalanche and EXT Escalade)

Callout Component Name

Preliminary Procedures

  1. Remove the body side trim panel. Refer to Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/E61) , Rear Quarter Trim Panel Replacement - Left Side (Extended Wheelbase w/o E61) , Rear Quarter Trim Panel Replacement - Left Side (Standard Wheelbase w/o E61) .
  2. Remove the liftgate close actuator motor control module. Refer to Liftgate Close Actuator Motor Control Module Replacement (Except Avalanche and Escalade EXT) .
  3. Remove the accessory and liftgate control module, if required. Refer to Accessory and Liftgate Control Module Replacement .
1 Liftgate Close Actuator Bracket Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
30 N.m (22 lb ft)
2 Liftgate Close Actuator Bracket
scientia non olet · About LEMON Manuals