Rear Bumper Fascia Replacement (Escalade Premium)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Bumper Fascia & Bolts (Escalade Premium)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the rear wheelhouse inner panel liner. Refer to Rear Wheelhouse Panel Liner Replacement (RPO X88 Chevrolet, RPO O88 GMC) , Rear Wheelhouse Panel Liner Replacement (RPO HP2) .
1	Rear Bumper Fascia Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Rear Bumper Fascia Plastic Bolt (Qty: 3) Procedure Disconnect the rear object detection sensor harness located in the right end of the fascia and any other electrical connectors before attempting removal. Reach between the fascia and the rear quarter panel to loosen the bolts. DO NOT pull on the fascia when reaching to loosen the bolts. Tighten 9 N.m (80 lb in)
3	Rear Bumper Fascia Bolt (Qty: 4) Tighten 9 N.m (80 lb in)
4	Rear Bumper Fascia Plastic Retainer (Qty: 2)
5	Fascia Bumper Fascia Procedure Transfer parts as needed.