Torque Converter Housing with Fluid Pump Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Converter Housing & Fluid Pump & Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	NEW Fluid Pump Seal
2	Torque Converter (with Fluid Pump) Housing Assembly CAUTION: Ensure the turbine shaft (O-ring) seal is not installed prior to installing the torque converter housing assembly. The seal may become cut or damaged during installation of the torque converter housing assembly.
3	Bolts M10 x 50 (Qty: 9) CAUTION: Refer to Fastener Caution . Procedure Tighten in the sequence shown. Tighten 72 N.m (53 lb ft)
4	NEW Turbine Shaft (O-Ring) Seal