Control Valve Upper Body Assembly Cleaning and Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Control Valve Upper Body Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result. CAUTION: Do not remove the exhaust backfill pressure relief retainer, spring, or ball valve (refer to arrow in above illustration for location). The retainer is set to a precise depth. Replacement of this retainer could cause internal transmission damage. CAUTION: After cleaning the transmission components, allow to air dry. Do not use cloth or paper towels in order to dry any transmission components. Lint from the towels can cause component failure. CAUTION: Do not reuse cleaning solvents. Previously used solvents may deposit sediment which may damage the component. Preliminary Procedure Clean and inspect all valve components, locating pins, and the valve body. The control valve upper body is replaceable only as an assembly.
1	Clutch Boost Valve Train
2	1-2-3-4 Clutch Regulator Valve Train
3	3-5 Reverse Clutch Regulator Valve Train
4	Clutch Boost Valve Train
5	2-6 Clutch Regulator Valve Train
6	Clutch Boost Valve Train
7	CBR1/4-5-6 Clutch Regulator Valve Train
8	Actuator Feed Limit Valve Train
9	Control Valve Body Locator Pin
10	Control Valve Body Locator Pin
11	Control Valve Body Locator Pin