LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 398 (Automatic Transmission - 6L80/6L90 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Disassemble >> Input and Output Speed Sensor Assembly Removal

Input and Output Speed Sensor Assembly Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input And Output Speed Sensor Assembly
GM1627571Courtesy of GENERAL MOTORS CORP.
Input and Output Speed Sensor Assembly Removal

Callout Component Name
1 Bolt M6 x 20 (Qty: 2)
2 Speed Sensor Electrical Connector
TIP:  Release the connector lock before disconnecting.
3 A/Trans Input and Output Speed Sensor Assembly
4 A/Trans Input and Output Speed Sensor Wiring Harness Clip (Qty: 2)
TIP:  Inspect the clips and replace if damaged.
scientia non olet · About LEMON Manuals