Upper to Lower Control Valve Body Assembly Assemble
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Upper to Lower Control Valve Body Assembly Assemble
| Callout | Component Name |
|---|---|
| 1 | Control Valve Body Ball Check Valve (Qty: 7)
CAUTION:
Do not use any type of grease or other material to hold the check ball valves in place during assembly. Grease will cause the valves to not operate properly, resulting in damage to the transmission. TIP: Refer to Ball Check Valve Locations . |
| 2 | Control Valve Body Spacer (w/Gasket) Plate Assembly
CAUTION:
Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage. |
| 3 | Control Valve Lower Body Assembly TIP: Turn the valve body assembly over after installing to upper body. |
| 4 | Bolt M5 x 36 (Qty: 12)
CAUTION:
Refer to Fastener Caution . Procedure Tighten the bolts in the sequence shown. Tighten 8 N.m (71 lb in). |