LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 398 (Automatic Transmission - 6L80/6L90 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Control Solenoid Valve Assembly Installation

Control Solenoid Valve Assembly Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Solenoid Valve Assembly
GM1627736Courtesy of GENERAL MOTORS CORP.
Control Solenoid Valve Assembly Installation

Callout Component Name
1 Control Solenoid (w/Body and TCM) Valve Assembly
TIP:  Note the locator pin on the control valve lower body assembly while aligning the control solenoid valve assembly.
2 Bolt M5 x 53 (Qty: 2)
TIP:  Hand tighten only.
3 Bolt M5 x 55 (Qty: 4)
TIP:  Hand tighten only.
4 Bolt M5 x 45 (Qty: 5)
TIP:  Hand tighten only.
scientia non olet · About LEMON Manuals