Water Pump Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the water pump (300) and NEW gaskets (306).
- Install the water pump bolts (301).
- Tighten the water pump bolts a first pass to 15 N.m (11 lb ft).
- Tighten the water pump bolts a final pass to 30 N.m (22 lb ft).
CAUTION:
DO NOT use cooling system seal tabs, or similar compounds, unless otherwise instructed. The use of cooling system seal tabs, or similar compounds, may restrict coolant flow through the passages of the cooling system or the engine components. Restricted coolant flow may cause engine overheating and/or damage to the cooling system or the engine components/assembly.
NOTE:
All gasket surfaces are to be free of oil or other foreign material during assembly.
CAUTION:
Refer to Fastener Caution .