LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm and Push Rod Removal

Valve Rocker Arm and Push Rod Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rocker Arms And Bolts
    GM1814082Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:

    Place the valve rocker arms, valve pushrods, and pivot support, in a rack so they can be installed in the same location from which they were removed.

  1. On engines with offset intake rocker arms (1), remove the valve rocker arm bolts and valve rocker arms - engine RPOs LY6, L94, L96, and L9H.
    2. Fig 2: Rocker Arms And Bolts
    GM260140Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:

    Place the valve rocker arms, valve pushrods, and pivot support, in a rack so they can be installed in the same location from which they were removed.

  2. On engines without offset rocker arms (1), remove the rocker arm bolts and valve rocker arms - engine RPOs L20, LMG and LC9.
    3. Fig 3: Rocker Arm Pivot Support
    GM260141Courtesy of GENERAL MOTORS CORP.
  3. Remove the valve rocker arm pivot support.
    4. Fig 4: Pushrods
    GM260142Courtesy of GENERAL MOTORS CORP.
  4. Remove the pushrods.
scientia non olet · About LEMON Manuals