LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Throttle Body Assembly Installation

Throttle Body Assembly Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Throttle Body Assembly
    GM1401966Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the throttle body studs, as required. Tighten the throttle body studs to 6 N.m (53 lb in).
    2. NOTE:

    DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.

  2. Install the throttle body gasket (509) to the intake manifold. Align the locating tab of the gasket with the notch in the manifold.
  3. Install the throttle body (508), bolts (538), and nuts (507). Tighten the throttle body nuts and bolts to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals