Oil Level Indicator and Tube Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the O-ring seal (421) for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be used again.
- Lubricate the O-ring seal with clean engine oil.
- Install the O-ring seal onto the oil level indicator tube (420).
- Install the oil level indicator tube into the engine block and rotate into proper position.
- Install the tube bolt (419) and tighten to 25 N.m (18 lb ft).
- Install the oil level indicator (418) into the tube.
CAUTION:
Refer to Fastener Caution .