LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Intake Manifold Removal (Without Active Fuel Management)

Intake Manifold Removal (Without Active Fuel Management)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: PCV Dirty-Air Hose
    GM1658148Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • The intake manifold, throttle body, fuel injection rail, and fuel injectors may be removed as an assembly. If not servicing the individual components, remove the manifold as a complete assembly.
    • DO NOT use the intake manifold-to-cylinder head gaskets again.
  1. Remove the positive crankcase ventilation (PCV) hose - dirty air (716).
    2. Fig 2: MAP Sensor
    GM1401987Courtesy of GENERAL MOTORS CORP.
  2. Remove the manifold absolute pressure (MAP) sensor (714) and retainer (736), as required.
  3. Remove the O-ring (715) from the sensor, as required.
    4. Fig 3: Intake Manifold And Bolts
    GM1403311Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold bolts (512).
  5. Remove the intake manifold (500) with gaskets.
    6. Fig 4: Intake Manifold Gasket
    GM1277097Courtesy of GENERAL MOTORS CORP.
  6. Remove the intake manifold gaskets (514).
  7. Discard the intake manifold gaskets.
scientia non olet · About LEMON Manuals