LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Camshaft Removal

Camshaft Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Camshaft Retainer And Retainer Bolt
    GM1969013Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft retainer bolts (204) and retainer (203).
    2. Fig 2: Camshaft
    GM1704626Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.

  2. Remove the camshaft.
    1. Install the camshaft sprocket bolt or solenoid valve into the camshaft front bolt hole.
    2. Using the bolt or solenoid valve as a handle, carefully rotate and pull the camshaft out of the engine block.
    3. Remove the bolt or solenoid valve from the front of the camshaft.
scientia non olet · About LEMON Manuals