LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Removal

Automatic Transmission Flex Plate Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Automatic Transmission Flex Plate
    GM1658140Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:

    The flex plate does not use a locating pin for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flex plate bolts. This procedure requires a 3 stage tightening process.

  1. Remove the engine flex plate bolts.
  2. Remove the flex plate.
scientia non olet · About LEMON Manuals