Installation Procedure
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Position the engine mount to the engine.
- Working through the wheelhouse opening, install the engine mount to engine bolts (1).
Tighten
Tighten the bolts to 50 N.m (37 lb ft).
- Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
- Remove the adjustable jack from the engine block.
- Install the engine mount to frame bolts (1).
Tighten
Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
- Install the A/C compressor bracket. Refer to Air Conditioning Compressor Bracket Replacement (HP2) .
- If the vehicle is equipped with 4WD, Install the front drive axle bracket and bolts.
Tighten
Tighten the bolts to 90 N.m (67 lb ft).
- If the vehicle is equipped with 4WD, Install the front drive axle. Refer to Differential Carrier Assembly Replacement (8.25 inch) , Differential Carrier Assembly Replacement (4WD 1500 Hybrid) , Differential Carrier Assembly Replacement (9.25 inch) .
- Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side .
CAUTION:
Refer to Fastener Caution .