Cylinder Deactivation (Active Fuel Management) Oil Pressure Relief Valve Diagnosis and Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
- EN-47971 Oil Pressure Gauge Adapter
- J 21867 Pressure Gauge
- J-21867-16 Oil Pressure Adapter
- Active Fuel Management Oil Pressure Relief Valve Diagnosis and Testing is applicable for RPO LY2/LC9/LY5/LMG/LY6/L76/L9H.
- This test is performed to verify the operation of the active fuel management oil pressure relief valve located in the oil pan. Refer to Cylinder Deactivation (Active Fuel Management) System Description , and Lubrication Description (with Active Fuel Management) , Lubrication Description (without Active Fuel Management) .
- Remove the oil filter and install the EN-47971 (1).
- Install the J 21867 (2), or equivalent to the EN-47971 (1).
- Remove the oil pressure sensor and install the J-21867-16 .
- Install the J 21867 (1), or equivalent to the J-21867-16 (2).
- Run the engine and measure the engine oil pressure while observing both gauges.
Operate the throttle, as required, to increase and decrease the engine oil pressure.
- With the engine running and the lower pressure gauge (2) measuring below 379 kPa (55 psi), both gauges should display the same pressure reading. If the readings are not the same and the lower gauge (2) has a higher reading, the active fuel management oil pressure relief valve is stuck in the open position or the valve lifter oil manifold filter is plugged.
- With the engine running and the lower pressure gauge (2) measuring above 379 kPa (55 psi), the upper gauge (1) should display no greater than 379-517 kPa (55-75 psi). If the reading on the upper gauge (1) is greater than 517 kPa (75 psi), the active fuel management oil pressure relief valve is stuck in the closed position.
IMPORTANT:If both gauges are display equal pressures, but the pressures are low, debris could be present in the oil pressure relief valve causing an intermittent or constant open condition. Check the oil pressure relief valve for debris that could cause the valve to stick open and reduce engine oil flow and/or pressure simultaneously.
- Repair, as required.
IMPORTANT: