LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 360 (Automatic Transmission - 6L80/6L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Yukon) , Front Bumper Fascia Replacement (Escalade) , Front Bumper Fascia Replacement (Tahoe) , Front Bumper Fascia Replacement (Avalanche) , Front Bumper Fascia Replacement (Z71) .
  2. Remove the front upper fascia support fasteners in order to tip the bracket back. Refer to Front Upper Fascia Support Bracket Replacement .
    3. Fig 1: Transmission Fluid Cooler Inlet And Outlet Pipes
    GM2717444Courtesy of GENERAL MOTORS CORP.
  3. Remove the transmission fluid cooler inlet pipe (1) from the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Remove the transmission fluid cooler outlet pipe (2) from the auxiliary oil cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the engine protection shield. Refer to Engine Shield Replacement .
    7. Fig 2: Oil Cooling Lines And Bolt
    GM1705099Courtesy of GENERAL MOTORS CORP.
  7. Remove the cooling lines from the transmission. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
    8. Fig 3: Right Differential Carrier Mounting Nuts And Washers
    GM1751768Courtesy of GENERAL MOTORS CORP.
  8. Remove the right differential carrier mounting nuts and washers.
    9. Fig 4: Lower Shock Module Bolts
    GM1761077Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Do not use air powered tools in order to disassemble or assemble any vehicle component. Bolt torques are vital to diagnosis. You can detect bolt torques only when using hand tools. Improper bolt torques can contribute to vehicle repair problems.

  9. Remove the right front shock rear mounting bolt only from the lower control arm.
  10. Remove the oil cooling lines rearward from the vehicle.
scientia non olet · About LEMON Manuals