LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 341 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement (2500) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knuckle on the lower ball joint. Refer to Lower Control Arm Replacement , Lower Control Arm Replacement .
  2. Install the upper ball joint in the knuckle. Refer to Upper Control Arm Replacement (1500) , Upper Control Arm Replacement (2500) .
  3. Connect the outer tie rod to the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  4. Install the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (1500) , Front Wheel Hub, Bearing, and Seal Replacement (2500) .
  5. Install the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .
    6. Fig 1: Supporting Lower Control Arm
    GM1869898Courtesy of GENERAL MOTORS CORP.
  6. Remove the support from the lower control arm.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Verify the front wheel alignment> Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals