Front Wheel Hub, Bearing, and Seal Replacement (1500)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Wheel Hub, Bearing, & Seal (1500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the brake rotor. Refer to Front Brake Rotor Replacement (1500 Series) , Front Brake Rotor Replacement (2500 Series) . Remove the speed sensor, if equipped. For hybrid vehicles, refer to Front Wheel Speed Sensor Replacement . For non-hybrid vehicles, refer to Front Wheel Speed Sensor Replacement . For vehicles equipped with 4WD, remove the wheel drive shaft from the wheel bearing and hub assembly. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .
1	Wheel Bearing and Hub Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 180 N.m (133 lb ft)
2	Wheel Hub and Bearing Assembly TIP: New wheel bearing comes with a wheel speed sensor installed.

Callout

Component Name

Preliminary Procedure

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the brake rotor. Refer to Front Brake Rotor Replacement (1500 Series) , Front Brake Rotor Replacement (2500 Series) .
Remove the speed sensor, if equipped.
- For hybrid vehicles, refer to Front Wheel Speed Sensor Replacement .
- For non-hybrid vehicles, refer to Front Wheel Speed Sensor Replacement .
For vehicles equipped with 4WD, remove the wheel drive shaft from the wheel bearing and hub assembly. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .

Wheel Bearing and Hub Bolt (Qty: 3)

CAUTION:

Refer to Fastener Caution .

Tighten
180 N.m (133 lb ft)

Wheel Hub and Bearing Assembly
TIP: New wheel bearing comes with a wheel speed sensor installed.