Stabilizer Shaft Link Replacement (2500)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stabilizer Shaft Link (2500/3500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield, if equipped. Refer to Engine Shield Replacement . Remove the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement (1500) , Stabilizer Shaft Link Replacement (2500) . Remove the stabilizer shaft insulator. Refer to Stabilizer Shaft Insulator Replacement (1500) , Stabilizer Shaft Insulator Replacement (2500) .
1	Stabilizer Shaft Link Retaining Nut CAUTION: Refer to Fastener Caution . Procedure Remove all traces of the original adhesive patch. Apply Threadlocker GM P/N 12345382 (Canadian P/N 10953489) BLUE LOCTITE # 242 on the threads of the bolt. Tighten 23 N.m (17 lb ft)
2	Front Stabilizer Shaft Insulator (Qty: 4)
3	Front Stabilizer Shaft Washer (Qty: 2)
4	Front Stabilizer Shaft Spacer
5	Front Stabilizer Shaft Washer
6	Front Stabilizer Shaft Bolt