LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Rear Drive Axle) >> Repair Instructions >> Drive Pinion Housing and/or Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Inner Pinion Bearing Cup
    GM739952Courtesy of GENERAL MOTORS CORP.
  1. Using the J 37624 (2) and the GE-8092 Driver Handle (1), Install the inner pinion bearing cup into the pinion gear bearing retainer.
    2. Fig 2: Installing Outer Pinion Bearing Cup
    GM739946Courtesy of GENERAL MOTORS CORP.
  2. Using the J 8608 (2) and the GE-8092 Driver Handle (1), install the outer pinion bearing cup into the pinion gear bearing retainer.
  3. Apply sealant to surface of the selective shim. Refer to Adhesives, Fluids, Lubricants, and Sealers .
    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the pinion gear bearing retainer and bolts tighten to 88 N.m (65 lb ft).
  5. Install the drive pinion flange/yoke and/or oil seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement .
  6. Install the rear propeller shaft from the vehicle. Refer to Rear Propeller Shaft Replacement .
  7. Install the rear axle shafts. Refer to Rear Axle Shaft and/or Gasket Replacement .
  8. Fill the axle with axle lubricant. Refer to Differential Oil Replacement (8.6 Inch Axle) , Differential Oil Replacement (10.5 Inch Axle) , Differential Oil Replacement (9.5LD Inch Axle) .
  9. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals