Rear Axle Shaft and/or Gasket Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Axle Shaft And/Or Gasket

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
1	Axle Shaft Bolt (Qty: 8) CAUTION: Refer to Fastener Caution . Tighten 185 N.m (137 lb ft)
2	Rear Axle Shaft
3	Rear Axle Shaft Gasket TIP: When installing the NEW gasket, apply a small amount of clean grease to hold the gasket in place while aligning the mounting hole in the axle shaft and the hub.