LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Parking Brake System) >> Repair Instructions >> Rear Parking Brake Anchor Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Backing Plate And Bolts
    GM1497147Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake backing plate to the disc brake backing plate.
  2. Perform the following procedure before installing the park brake backing plate bolts.
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
    3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the park brake backing plate bolts and tighten to 135 N.m (100 lb ft).
  4. Install the rear axle shaft. Refer to Rear Axle Shaft Replacement .
  5. Install the park brake shoe. Refer to Parking Brake Shoe Replacement (2500 Series) , Parking Brake Shoe Replacement (1500 Series) .
    6. Fig 2: Park Brake Cable & Actuator Lever
    GM1688693Courtesy of GENERAL MOTORS CORP.
  6. Connect the park brake cable to the park brake actuator lever.
  7. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  8. Adjust the park brake shoe. Refer to Parking Brake Adjustment (1500 Without JNC) .
scientia non olet · About LEMON Manuals