LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Parking Brake System) >> Repair Instructions >> Parking Brake Actuator Replacement (1500 Series) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Cable & Actuator Lever
    GM1688693Courtesy of GENERAL MOTORS CORP.
  1. Install the park brake actuator lever, pin and adjuster wheel to the backing plate.
  2. Install the park brake shoe. Refer to Parking Brake Shoe Replacement (2500 Series) , Parking Brake Shoe Replacement (1500 Series) .
  3. Adjust the park brake shoe. Refer to Parking Brake Adjustment (1500 Without JNC) .
  4. Install the rear park brake cable to the park brake actuator lever.
  5. Install the park brake cable to the mounting bracket until the locking tabs snap into place.
  6. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
  7. Apply and release the park brake lever 3 times.
scientia non olet · About LEMON Manuals