LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Interior Trim And Interior Paneling) >> Repair Instructions >> Liftgate Trim Panel Replacement

Liftgate Trim Panel Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Liftgate Trim Panel
GM1671018Courtesy of GENERAL MOTORS CORP.
Liftgate Trim Panel Replacement

Callout Component Name
Preliminary Procedure 
Remove liftgate window upper garnish molding. Refer to Liftgate Garnish Molding Replacement .
1 Liftgate Trim Finish Panel Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Liftgate Trim Finish Panel Assembly
  1. Pull outward to disengage retainers and clips.
  2. Disconnect electrical connector.
3 Liftgate Trim Finish Panel Retainer (Qty: 12)
4 Liftgate Trim Finish Panel Clip (Qty: 5)
scientia non olet · About LEMON Manuals