Liftgate Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Preliminary Procedure Remove the liftgate strut. Refer to Liftgate Strut Replacement (Except Avalanche and Escalade EXT) . Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) .
1	Liftgate Window Upper Garnish Molding Assembly TIP: Pull down and out to disengage retainers.
2	Liftgate Window Upper Garnish Molding Retainer (Qty: 9)

Callout

Component Name

WARNING:

When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedure

Remove the liftgate strut. Refer to Liftgate Strut Replacement (Except Avalanche and Escalade EXT) .
Disconnect the power liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) .

Liftgate Window Upper Garnish Molding Assembly
TIP: Pull down and out to disengage retainers.

Liftgate Window Upper Garnish Molding Retainer (Qty: 9)