Liftgate Replacement (Except Avalanche and EXT Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Assembly And Body Side Hinge Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disconnect the strut rods. Refer to Liftgate Strut Replacement (Except Avalanche and Escalade EXT) . Remove the rear door upper garnish molding. Refer to Rear Door Upper Garnish Molding Replacement . Disconnect the liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) . Disconnect the electrical connectors.
1	Liftgate Body Side Hinge Nut (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft)
2	Liftgate Assembly TIP: Calibrate the power liftgate. Refer to Liftgate Calibration (Except Avalanche and EXT Escalade) .

Callout

Component Name

Preliminary Procedures

Disconnect the strut rods. Refer to Liftgate Strut Replacement (Except Avalanche and Escalade EXT) .
Remove the rear door upper garnish molding. Refer to Rear Door Upper Garnish Molding Replacement .
Disconnect the liftgate actuator rod. Refer to Liftgate Actuator Rod Replacement (Except Avalanche and EXT Escalade) .
Disconnect the electrical connectors.

Liftgate Body Side Hinge Nut (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
25 N.m (18 lb ft)

Liftgate Assembly
TIP: Calibrate the power liftgate. Refer to Liftgate Calibration (Except Avalanche and EXT Escalade) .