LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary and Secondary Latch Replacement

Hood Primary and Secondary Latch Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hood Primary And Secondary Latch
GM1673076Courtesy of GENERAL MOTORS CORP.
Hood Primary and Secondary Latch Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the headlamps. Refer to Headlamp Replacement (Cadillac Escalade) , Headlamp Replacement (Tahoe, Avalanche) , Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) , Headlamp Replacement (Escalade PLATINUM) , Headlamp Replacement (Non HID) , Headlamp Replacement (Yukon) , Headlamp Replacement (GMC Yukon Two-mode Hybrid) .
  2. Remove the grille support. Refer to Radiator Grille Reinforcement Support Replacement .
  3. Disconnect the hood latch cable. Refer to Hood Primary Latch Release Cable Replacement .
1 Hood Latch Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Hood Latch
TIP:  Disconnect the electrical connector.