LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary Latch Release Cable Replacement

Hood Primary Latch Release Cable Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hood Primary Latch Release Cable
GM1670885Courtesy of GENERAL MOTORS CORP.
Hood Primary Latch Release Cable Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the headlamps. Refer to Headlamp Replacement (Cadillac Escalade) , Headlamp Replacement (Tahoe, Avalanche) , Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) , Headlamp Replacement (Escalade PLATINUM) , Headlamp Replacement (Non HID) , Headlamp Replacement (Yukon) , Headlamp Replacement (GMC Yukon Two-mode Hybrid) .
  2. Remove the grille support. Refer to Radiator Grille Reinforcement Support Replacement .
  3. Remove the hood release handle. Refer to Hood Primary Latch Release Cable Handle Replacement .
1 Hood Latch Release Cable Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Hood Latch Release Cable
  • Release the cable from the latch assembly and pull through the dash panel.
  • Attach mechanics wire to existing cable to ease installation of the new cable.
scientia non olet · About LEMON Manuals