LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary Latch Release Cable Handle Replacement

Hood Primary Latch Release Cable Handle Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hood Primary Latch Release Cable Handle
GM1674991Courtesy of GENERAL MOTORS CORP.
Hood Primary Latch Release Cable Handle Replacement

Callout Component Name
Preliminary Procedure 
Remove the body hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
1 Hood Latch Release Handle Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Hood Latch Release Handle
scientia non olet · About LEMON Manuals