Front Fender Replacement - Left Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Fender - Left Side

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the headlamp. Refer to Headlamp Replacement (Cadillac Escalade) , Headlamp Replacement (Tahoe, Avalanche) , Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) , Headlamp Replacement (Escalade PLATINUM) , Headlamp Replacement (Non HID) , Headlamp Replacement (Yukon) , Headlamp Replacement (GMC Yukon Two-mode Hybrid) . Remove the radiator support diagonal brace. Refer to Radiator Support Diagonal Brace Replacement . Remove the upper rear fender bracket. Refer to Front Fender Rear Upper Bracket Replacement . Remove the auxiliary battery tray. Refer to Auxiliary Battery Tray Replacement Remove the left hood hinge. Refer to Hood Hinge Replacement . Remove the left hood open assist spring. Refer to Hood Open Assist Spring Replacement . Remove the underhood electrical center/junction block. Refer to Underhood Electrical Center or Junction Block Replacement . Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
1	Fender Mounting Bolt (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 25 N.m (18 lb ft)
2	Fender Mounting Bolt (Qty: 3) Tighten 30 N.m (22 lb ft) Procedure Apply threadlock compound to the bolts.
3	Fender Mounting Clip (Qty: 3)
4	Fender Mounting Nut (Qty: 2) Tighten 25 N.m (18 lb ft)
5	Fender Assembly TIP: Transfer any necessary additional parts as needed.