LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 295 (Wiper System And Washer System) >> Repair Instructions >> Rear Window Wiper Motor Replacement

Rear Window Wiper Motor Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Window Wiper Motor
GM1669967Courtesy of GENERAL MOTORS CORP.
Rear Window Wiper Motor Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the liftgate interior trim panel. Refer to Liftgate Trim Panel Replacement .
  2. Remove the rear wiper arm assembly. Refer to Rear Window Wiper Arm Replacement (Yukon, Tahoe, Hybrid Two-mode) .
  3. Remove the rear wiper motor pivot shaft nut and spacer.
1 Rear Window Wiper Motor Assembly Nut (Qty: 2)
CAUTION:

Refer to Fastener Caution .

NOTE:

Tighten the rear wiper motor pivot shaft nut after the motor and pivot shaft spacer have been installed.


Tighten 
9 N.m (80 lb in)
2 Rear Window Wiper Motor Assembly

Procedure

  1. Pull the wiper motor forward towards the front of the vehicle.
  2. Disconnect the electrical connector.
  3. Remove the rear wiper motor from the inner liftgate panel.
  4. Check the rear wiper shaft spacer upon installation of the new wiper motor to ensure proper position of the spacer to the rear liftgate panel.
scientia non olet · About LEMON Manuals