Liftgate Center Applique Replacement (GMC Yukon Hybrid 2 Mode)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Center Applique (GMC Yukon Hybrid 2 Mode)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open and support the liftgate assembly. Remove the rear wiper motor. Refer to Rear Window Wiper Motor Replacement . Do Not Use Air-Type Power Tools when Performing the Following Steps: Use a needle-nose type vice grip plier and ratchet type wrench. Hold the very end of the applique studs secure. Slowly ratchet the nut from each of the applique studs. Use the access holes in the panel to access and remove the nuts. Using a 8 mm socket, push the socket onto the retainers in order to release the retainer ears from the inner panel. Pull and remove the liftgate center applique from the exterior side of the body panel. Disconnect all electrical connectors from the applique panel.
1	Liftgate Center Applique Assembly Nut (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 6 N.m (53 lb in)
2	Integral Retainer (Qty: 2) TIP: Use a 8 mm socket to depress the ears on the retainers to remove the applique from the liftgate panel.
3	Rear Liftgate Harness Electrical Connector TIP: Disconnect the electrical connector after releasing the retainers.
4	Liftgate Center Applique Assembly Procedure Pull the applique rearward in order to remove the applique from the liftgate panel. Transfer the rearview camera, if equipped. Refer to Rearview Camera Replacement (Endgate) , Rearview Camera Replacement (Liftgate) .