LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Throttle Body Installation

Throttle Body Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body Assembly
    GM1401966Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the throttle body studs, as required.

    Tighten:  Tighten the throttle body studs to 6 N.m (53 lb in).

    2. IMPORTANT: DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.
  2. Install the throttle body gasket (509) to the intake manifold. Align the locating tab of the gasket with the notch in the manifold.
  3. Install the throttle body (508), bolts (538), and nuts (507).

    Tighten:  Tighten the throttle body nuts and bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals