LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 273 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (5 Of 5)) >> Off-Vehicle Repair Instructions (3 Of 3) >> Engine Coolant Air Bleed Pipe and Hole Cover Installation (RPO LC9/LY5/LMG/L76)

Engine Coolant Air Bleed Pipe and Hole Cover Installation (RPO LC9/LY5/LMG/L76)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Position the O-ring seal onto the nipple portion of the pipe.
  1. Install the seals (308) onto the engine coolant air bleed pipe and covers.
    2. Fig 2: View Of Engine Coolant Air Bleed Pipe
    GM1401993Courtesy of GENERAL MOTORS CORP.
  2. Install the pipe (307) and seals (308).
    3. NOTE: Refer to Fastener Notice .
  3. Install the bolts (309).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    4. Fig 3: View Of Air Bleed Pipe Bolts & Seals
    GM1402001Courtesy of GENERAL MOTORS CORP.
  4. Install the covers (313) and seals (308).
  5. Install the bolts (312).

    Tighten:  Tighten the cover bolts to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals