Oil Pan Cleaning and Inspection
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the oil filter fitting (438), as required.
- Remove the active fuel management oil pressure relief valve (455) and washer.
- Inspect the oil pressure relief valve for proper operation. Lightly depress the valve (2). The valve spring (1) should seat the valve to the proper closed position.
- Remove the oil level sensor (727) and O-ring (728).
- Remove the bolts (427) and baffle (428).
- Remove the oil pan cover (434), bolts (435), and gasket (433).
- Clean the oil pan in solvent.
- Dry the oil pan with compressed air.
- Inspect the oil pan for the following conditions:
- Damaged gasket surfaces (1)
- Restrictions within the oil passages (2) of the pan
- Damaged oil filter seal surface (3)
- Threaded oil level sensor hole (4) for damage
CAUTION:
Refer to Safety Glasses and Compressed Air Caution
.